Position sizing basics: how much to put in each trade

Position sizing is deciding how much money goes into each investment or trade. Two people can follow exactly the same buy and sell signals and end up with very different results because one puts in much more per trade than the other.

It gets less attention than choosing what to buy, but it often matters as much for how bad the bad periods are.

Why sizing matters

The size of a position sets how much a single loss can hurt. Losing half of a position that is 5% of a portfolio costs 2.5% of the portfolio. Losing half of a position that is 50% of the portfolio costs 25%. The signal was the same; the damage was ten times larger.

Because losses compound, large positions also make recovery harder. After a 25% fall, the remaining money needs a 33% gain to get back to the start.

Common methods

Fixed amount. The same sum in every trade, such as £1,000. Simple, but the share of the portfolio changes as the portfolio grows or shrinks.

Fixed percentage. The same share of the portfolio in every trade, such as 5%. Positions grow after gains and shrink after losses.

Fixed risk. Size each position so that, if a stop-loss is hit, the loss is a set share of the portfolio, such as 1%. A wider stop means a smaller position.

Volatility-based. Smaller positions in jumpier investments and larger ones in calmer ones, so each contributes a similar amount of swing.

All in. The whole portfolio in one position at a time. This is how many simple backtests are run, including ours, and it is the most concentrated approach.

How sizing shows up in a backtest

A backtest that puts all the money into each trade shows the full effect of every win and loss. Its drawdowns are the drawdowns of one concentrated position. Scaling the same signals down to a fraction of the portfolio would shrink both the gains and the falls, and the rest of the money would be doing something else, such as earning interest or held in other investments.

Our published backtests test one ticker at a time and compare each strategy with buying and holding the same ticker over the same dates. That keeps the comparison like for like. It is not a suggestion of how much anyone should put into one ticker.

Concentration and diversification

Spreading money across many unrelated investments reduces the effect of any single one going wrong. Sizing and diversification work together: small positions across many holdings lower the chance that one bad outcome dominates. They do not remove the risk of a broad market fall, which affects most holdings at once.

A few cautions

Increasing position size after losses to win money back is one of the fastest ways to make a bad period much worse. Sizing up after a run of wins can do the same when the run ends. Rules decided in advance are easier to keep than decisions made in the moment.

Leverage is a form of position sizing. Borrowing to invest, or using a leveraged fund, magnifies both gains and falls. Our note on leveraged ETFs explains how daily resetting adds a further cost.

What sizing cannot do

It cannot turn a strategy that loses money on average into one that makes money. It changes how large the swings are and how survivable the bad periods are. The decision about how much to put into any investment depends on your goals, your time horizon and how much loss you can take.

A worked illustration

This is an illustration, not a real portfolio. A £20,000 portfolio uses fixed-risk sizing of 1%, so the most it is willing to lose on one trade is £200. A share costs £10 and the stop is at £9, so the risk per share is £1. The position is 200 shares, worth £2,000, which is 10% of the portfolio. If the stop were at £8, the risk per share would be £2, and the position would be 100 shares, worth £1,000.

The wider the stop, the smaller the position. That keeps the planned loss the same, though a gap below the stop can still make the real loss larger.

Sizing over time

Fixed-percentage sizing has a useful property: after losses, positions shrink, which slows the damage; after gains, they grow. Fixed-amount sizing does the opposite in relative terms, becoming a larger share of a shrinking portfolio. Neither is right for everyone, but knowing which one a backtest uses explains a lot about how its bad periods look.

Finally, a sizing rule only helps if it is followed when it is uncomfortable. The moments when a rule says to keep positions small are often the moments when a trade looks most certain, and the moments when it says to keep going are often after painful losses. Writing the rule down before trading, and checking each trade against it, is the simplest way to keep it.

This is research, not financial advice. Past results, real or simulated, do not tell you what will happen next.

What is position sizing?

Deciding how much money goes into each investment or trade. It sets how much a single loss can cost the whole portfolio.

What is the 1% rule in position sizing?

Sizing each position so that, if its stop-loss is hit, the loss is about 1% of the portfolio. It is a convention, not a law, and gaps can make real losses larger.

How do StrategyLens backtests handle sizing?

Each backtest tests one ticker and is compared with buying and holding the same ticker over the same dates, so the comparison is like for like. It is not a suggestion of how much to put into one ticker.